????
Your IP : 13.59.82.60
/* SPDX-License-Identifier: GPL-2.0 WITH Linux-syscall-note */
#ifndef _LINUX_VHOST_TYPES_H
#define _LINUX_VHOST_TYPES_H
/* Userspace interface for in-kernel virtio accelerators. */
/* vhost is used to reduce the number of system calls involved in virtio.
*
* Existing virtio net code is used in the guest without modification.
*
* This header includes interface used by userspace hypervisor for
* device configuration.
*/
#include <linux/types.h>
#include <linux/virtio_config.h>
#include <linux/virtio_ring.h>
struct vhost_vring_state {
unsigned int index;
unsigned int num;
};
struct vhost_vring_file {
unsigned int index;
int fd; /* Pass -1 to unbind from file. */
};
struct vhost_vring_addr {
unsigned int index;
/* Option flags. */
unsigned int flags;
/* Flag values: */
/* Whether log address is valid. If set enables logging. */
#define VHOST_VRING_F_LOG 0
/* Start of array of descriptors (virtually contiguous) */
__u64 desc_user_addr;
/* Used structure address. Must be 32 bit aligned */
__u64 used_user_addr;
/* Available structure address. Must be 16 bit aligned */
__u64 avail_user_addr;
/* Logging support. */
/* Log writes to used structure, at offset calculated from specified
* address. Address must be 32 bit aligned. */
__u64 log_guest_addr;
};
/* no alignment requirement */
struct vhost_iotlb_msg {
__u64 iova;
__u64 size;
__u64 uaddr;
#define VHOST_ACCESS_RO 0x1
#define VHOST_ACCESS_WO 0x2
#define VHOST_ACCESS_RW 0x3
__u8 perm;
#define VHOST_IOTLB_MISS 1
#define VHOST_IOTLB_UPDATE 2
#define VHOST_IOTLB_INVALIDATE 3
#define VHOST_IOTLB_ACCESS_FAIL 4
/*
* VHOST_IOTLB_BATCH_BEGIN and VHOST_IOTLB_BATCH_END allow modifying
* multiple mappings in one go: beginning with
* VHOST_IOTLB_BATCH_BEGIN, followed by any number of
* VHOST_IOTLB_UPDATE messages, and ending with VHOST_IOTLB_BATCH_END.
* When one of these two values is used as the message type, the rest
* of the fields in the message are ignored. There's no guarantee that
* these changes take place automatically in the device.
*/
#define VHOST_IOTLB_BATCH_BEGIN 5
#define VHOST_IOTLB_BATCH_END 6
__u8 type;
};
#define VHOST_IOTLB_MSG 0x1
#define VHOST_IOTLB_MSG_V2 0x2
struct vhost_msg {
int type;
union {
struct vhost_iotlb_msg iotlb;
__u8 padding[64];
};
};
struct vhost_msg_v2 {
__u32 type;
__u32 reserved;
union {
struct vhost_iotlb_msg iotlb;
__u8 padding[64];
};
};
struct vhost_memory_region {
__u64 guest_phys_addr;
__u64 memory_size; /* bytes */
__u64 userspace_addr;
__u64 flags_padding; /* No flags are currently specified. */
};
/* All region addresses and sizes must be 4K aligned. */
#define VHOST_PAGE_SIZE 0x1000
struct vhost_memory {
__u32 nregions;
__u32 padding;
struct vhost_memory_region regions[0];
};
/* VHOST_SCSI specific definitions */
/*
* Used by QEMU userspace to ensure a consistent vhost-scsi ABI.
*
* ABI Rev 0: July 2012 version starting point for v3.6-rc merge candidate +
* RFC-v2 vhost-scsi userspace. Add GET_ABI_VERSION ioctl usage
* ABI Rev 1: January 2013. Ignore vhost_tpgt field in struct vhost_scsi_target.
* All the targets under vhost_wwpn can be seen and used by guset.
*/
#define VHOST_SCSI_ABI_VERSION 1
struct vhost_scsi_target {
int abi_version;
char vhost_wwpn[224]; /* TRANSPORT_IQN_LEN */
unsigned short vhost_tpgt;
unsigned short reserved;
};
/* VHOST_VDPA specific definitions */
struct vhost_vdpa_config {
__u32 off;
__u32 len;
__u8 buf[0];
};
/* vhost vdpa IOVA range
* @first: First address that can be mapped by vhost-vDPA
* @last: Last address that can be mapped by vhost-vDPA
*/
struct vhost_vdpa_iova_range {
__u64 first;
__u64 last;
};
/* Feature bits */
/* Log all write descriptors. Can be changed while device is active. */
#define VHOST_F_LOG_ALL 26
/* vhost-net should add virtio_net_hdr for RX, and strip for TX packets. */
#define VHOST_NET_F_VIRTIO_NET_HDR 27
#endif