????
Your IP : 18.218.50.170
/* SPDX-License-Identifier: GPL-2.0 WITH Linux-syscall-note */
#ifndef _LINUX_VHOST_H
#define _LINUX_VHOST_H
/* Userspace interface for in-kernel virtio accelerators. */
/* vhost is used to reduce the number of system calls involved in virtio.
*
* Existing virtio net code is used in the guest without modification.
*
* This header includes interface used by userspace hypervisor for
* device configuration.
*/
#include <linux/vhost_types.h>
#include <linux/types.h>
#include <linux/ioctl.h>
#define VHOST_FILE_UNBIND -1
/* ioctls */
#define VHOST_VIRTIO 0xAF
/* Features bitmask for forward compatibility. Transport bits are used for
* vhost specific features. */
#define VHOST_GET_FEATURES _IOR(VHOST_VIRTIO, 0x00, __u64)
#define VHOST_SET_FEATURES _IOW(VHOST_VIRTIO, 0x00, __u64)
/* Set current process as the (exclusive) owner of this file descriptor. This
* must be called before any other vhost command. Further calls to
* VHOST_OWNER_SET fail until VHOST_OWNER_RESET is called. */
#define VHOST_SET_OWNER _IO(VHOST_VIRTIO, 0x01)
/* Give up ownership, and reset the device to default values.
* Allows subsequent call to VHOST_OWNER_SET to succeed. */
#define VHOST_RESET_OWNER _IO(VHOST_VIRTIO, 0x02)
/* Set up/modify memory layout */
#define VHOST_SET_MEM_TABLE _IOW(VHOST_VIRTIO, 0x03, struct vhost_memory)
/* Write logging setup. */
/* Memory writes can optionally be logged by setting bit at an offset
* (calculated from the physical address) from specified log base.
* The bit is set using an atomic 32 bit operation. */
/* Set base address for logging. */
#define VHOST_SET_LOG_BASE _IOW(VHOST_VIRTIO, 0x04, __u64)
/* Specify an eventfd file descriptor to signal on log write. */
#define VHOST_SET_LOG_FD _IOW(VHOST_VIRTIO, 0x07, int)
/* Ring setup. */
/* Set number of descriptors in ring. This parameter can not
* be modified while ring is running (bound to a device). */
#define VHOST_SET_VRING_NUM _IOW(VHOST_VIRTIO, 0x10, struct vhost_vring_state)
/* Set addresses for the ring. */
#define VHOST_SET_VRING_ADDR _IOW(VHOST_VIRTIO, 0x11, struct vhost_vring_addr)
/* Base value where queue looks for available descriptors */
#define VHOST_SET_VRING_BASE _IOW(VHOST_VIRTIO, 0x12, struct vhost_vring_state)
/* Get accessor: reads index, writes value in num */
#define VHOST_GET_VRING_BASE _IOWR(VHOST_VIRTIO, 0x12, struct vhost_vring_state)
/* Set the vring byte order in num. Valid values are VHOST_VRING_LITTLE_ENDIAN
* or VHOST_VRING_BIG_ENDIAN (other values return -EINVAL).
* The byte order cannot be changed while the device is active: trying to do so
* returns -EBUSY.
* This is a legacy only API that is simply ignored when VIRTIO_F_VERSION_1 is
* set.
* Not all kernel configurations support this ioctl, but all configurations that
* support SET also support GET.
*/
#define VHOST_VRING_LITTLE_ENDIAN 0
#define VHOST_VRING_BIG_ENDIAN 1
#define VHOST_SET_VRING_ENDIAN _IOW(VHOST_VIRTIO, 0x13, struct vhost_vring_state)
#define VHOST_GET_VRING_ENDIAN _IOW(VHOST_VIRTIO, 0x14, struct vhost_vring_state)
/* The following ioctls use eventfd file descriptors to signal and poll
* for events. */
/* Set eventfd to poll for added buffers */
#define VHOST_SET_VRING_KICK _IOW(VHOST_VIRTIO, 0x20, struct vhost_vring_file)
/* Set eventfd to signal when buffers have beed used */
#define VHOST_SET_VRING_CALL _IOW(VHOST_VIRTIO, 0x21, struct vhost_vring_file)
/* Set eventfd to signal an error */
#define VHOST_SET_VRING_ERR _IOW(VHOST_VIRTIO, 0x22, struct vhost_vring_file)
/* Set busy loop timeout (in us) */
#define VHOST_SET_VRING_BUSYLOOP_TIMEOUT _IOW(VHOST_VIRTIO, 0x23, \
struct vhost_vring_state)
/* Get busy loop timeout (in us) */
#define VHOST_GET_VRING_BUSYLOOP_TIMEOUT _IOW(VHOST_VIRTIO, 0x24, \
struct vhost_vring_state)
/* Set or get vhost backend capability */
/* Use message type V2 */
#define VHOST_BACKEND_F_IOTLB_MSG_V2 0x1
/* IOTLB can accept batching hints */
#define VHOST_BACKEND_F_IOTLB_BATCH 0x2
#define VHOST_SET_BACKEND_FEATURES _IOW(VHOST_VIRTIO, 0x25, __u64)
#define VHOST_GET_BACKEND_FEATURES _IOR(VHOST_VIRTIO, 0x26, __u64)
/* VHOST_NET specific defines */
/* Attach virtio net ring to a raw socket, or tap device.
* The socket must be already bound to an ethernet device, this device will be
* used for transmit. Pass fd -1 to unbind from the socket and the transmit
* device. This can be used to stop the ring (e.g. for migration). */
#define VHOST_NET_SET_BACKEND _IOW(VHOST_VIRTIO, 0x30, struct vhost_vring_file)
/* VHOST_SCSI specific defines */
#define VHOST_SCSI_SET_ENDPOINT _IOW(VHOST_VIRTIO, 0x40, struct vhost_scsi_target)
#define VHOST_SCSI_CLEAR_ENDPOINT _IOW(VHOST_VIRTIO, 0x41, struct vhost_scsi_target)
/* Changing this breaks userspace. */
#define VHOST_SCSI_GET_ABI_VERSION _IOW(VHOST_VIRTIO, 0x42, int)
/* Set and get the events missed flag */
#define VHOST_SCSI_SET_EVENTS_MISSED _IOW(VHOST_VIRTIO, 0x43, __u32)
#define VHOST_SCSI_GET_EVENTS_MISSED _IOW(VHOST_VIRTIO, 0x44, __u32)
/* VHOST_VSOCK specific defines */
#define VHOST_VSOCK_SET_GUEST_CID _IOW(VHOST_VIRTIO, 0x60, __u64)
#define VHOST_VSOCK_SET_RUNNING _IOW(VHOST_VIRTIO, 0x61, int)
/* VHOST_VDPA specific defines */
/* Get the device id. The device ids follow the same definition of
* the device id defined in virtio-spec.
*/
#define VHOST_VDPA_GET_DEVICE_ID _IOR(VHOST_VIRTIO, 0x70, __u32)
/* Get and set the status. The status bits follow the same definition
* of the device status defined in virtio-spec.
*/
#define VHOST_VDPA_GET_STATUS _IOR(VHOST_VIRTIO, 0x71, __u8)
#define VHOST_VDPA_SET_STATUS _IOW(VHOST_VIRTIO, 0x72, __u8)
/* Get and set the device config. The device config follows the same
* definition of the device config defined in virtio-spec.
*/
#define VHOST_VDPA_GET_CONFIG _IOR(VHOST_VIRTIO, 0x73, \
struct vhost_vdpa_config)
#define VHOST_VDPA_SET_CONFIG _IOW(VHOST_VIRTIO, 0x74, \
struct vhost_vdpa_config)
/* Enable/disable the ring. */
#define VHOST_VDPA_SET_VRING_ENABLE _IOW(VHOST_VIRTIO, 0x75, \
struct vhost_vring_state)
/* Get the max ring size. */
#define VHOST_VDPA_GET_VRING_NUM _IOR(VHOST_VIRTIO, 0x76, __u16)
/* Set event fd for config interrupt*/
#define VHOST_VDPA_SET_CONFIG_CALL _IOW(VHOST_VIRTIO, 0x77, int)
/* Get the valid iova range */
#define VHOST_VDPA_GET_IOVA_RANGE _IOR(VHOST_VIRTIO, 0x78, \
struct vhost_vdpa_iova_range)
#endif